CONTROL AND TOLERANCES
All the measurements, including angular measurements, are made at more than 250 mm
from the end of sections in order to take into account cutting deformations.
The check consists of measuring the deflection with respect to an axis perpendicular to the base plane.
This deflection must not exceed 0.25 % of the product's length.
The check is carried out on the product which is laid flat and at one of the ends flanged so that the largest dimension
is parallel to the base plane. For the common sections, the twisting angle of the free end with respect to the base plane
must not exceed 1 degree per metre.
For the other sections, particularly for asymmetrical tolerances, it may be necessary to allow a greater tolerance.
Tolerances on delivered quantities
Profilafroid+SAP reserve the right to deliver the number of bars or ordered tonnage to within a tolerance of plus or minus
10 %. For "fixed length" specified orders, this percentage varies according to the quantity and the kind of product.
For any tolerance not within these conditions, please consult us.
The weight per metre and the mechanical characteristics of the sections below are given for guidelines.
voestalpine Profilafroid and voestalpine S.A.P. reserve the right to stop manufacturing at any time certain references listed in this catalogue.
It is formally prohibited to reproduce - even partially - the contents of this document without written permission
from voestalpine Profilafroid and voestalpine S.A.P.
Packing unit :
minimum bundle of 0.5
or 1 metric ton depending on dimensions
quotation or order:
Tél.: 03 44 07 39 12
Fax : 03 44 07 39 13
2 rue de Beauvais
Tél. : 33/03 44 07 51 11
Fax.: 33/03 44 07 65 34
Route de Paris
Tél. : 33/02 32 27 64 27
Fax : 33/02 32 27 04 72